本帖最后由 ntjzt 于 2014-6-14 21:42 编辑
自己编译了一个企智通V2的OP 不知道哪个是刷机文件
cpu： marvell 88f6281 内存：ddr 512M 网卡 88e6161千兆 5口 88e1116 千兆 1口 附上启动信息，望高手指导 root@OpenWrt:/# dmesg Booting Linux on physical CPU 0 Linux version 3.3.8 (chao@Chao-VM) (gcc version 4.6.3 20120201 (prerelease) (Linaro GCC 4.6-2012.02) ) #1 Sat Aug 10 18:09:33 CST 2013 CPU: Feroceon 88FR131 [56251311] revision 1 (ARMv5TE), cr=00053977 CPU: VIVT data cache, VIVT instruction cache Machine: QiZhiTong By Chao Memory policy: ECC disabled, Data cache writeback On node 0 totalpages: 131072 free_area_init_node: node 0, pgdat c03443d0, node_mem_map c0360000 Normal zone: 1024 pages used for memmap Normal zone: 0 pages reserved Normal zone: 130048 pages, LIFO batch:31 pcpu-alloc: s0 r0 d32768 u32768 alloc=1*32768 pcpu-alloc: [0] 0 Built 1 zonelists in Zone order, mobility grouping on. Total pages: 130048 Kernel command line: console=ttyS0,9600 root=/dev/mtdblock2 rootfstype=squashfs PID hash table entries: 2048 (order: 1, 8192 bytes) Dentry cache hash table entries: 65536 (order: 6, 262144 bytes) Inode-cache hash table entries: 32768 (order: 5, 131072 bytes) Memory: 512MB = 512MB total Memory: 516296k/516296k available, 7992k reserved, 0K highmem Virtual kernel memory layout: vector : 0xffff0000 - 0xffff1000 ( 4 kB) fixmap : 0xfff00000 - 0xfffe0000 ( 896 kB) vmalloc : 0xe0800000 - 0xff000000 ( 488 MB) lowmem : 0xc0000000 - 0xe0000000 ( 512 MB) modules : 0xbf000000 - 0xc0000000 ( 16 MB) .text : 0xc0008000 - 0xc0307000 (3068 kB) .init : 0xc0307000 - 0xc0328000 ( 132 kB) .data : 0xc0328000 - 0xc0344a80 ( 115 kB) .bss : 0xc0344aa4 - 0xc035f480 ( 107 kB) NR_IRQS:114 gpiochip_add: registered GPIOs 0 to 31 on device: orion_gpio0 gpiochip_add: registered GPIOs 32 to 49 on device: orion_gpio1 sched_clock: 32 bits at 200MHz, resolution 5ns, wraps every 21474ms Calibrating delay loop... 1191.11 BogoMIPS (lpj=5955584) pid_max: default: 32768 minimum: 301 Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok Setting up static identity map for 0x288868 - 0x2888a4 NET: Registered protocol family 16 Kirkwood: MV88F6281-A0, TCLK=200000000. Feroceon L2: Enabling L2 Feroceon L2: Cache support initialised. initial MPP regs: 01111111 11113311 33331111 33003333 00005033 00000000 00000000 final MPP regs: 01111111 11113311 33331111 33003333 00005033 00000000 00000000 Kirkwood PCIe port 0: link down, ignoring bio: create slab <bio-0> at 0 SCSI subsystem initialized libata version 3.00 loaded. usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb Switching to clocksource orion_clocksource NET: Registered protocol family 2 IP route cache hash table entries: 4096 (order: 2, 16384 bytes) TCP established hash table entries: 16384 (order: 5, 131072 bytes) TCP bind hash table entries: 16384 (order: 4, 65536 bytes) TCP: Hash tables configured (established 16384 bind 16384) TCP reno registered UDP hash table entries: 256 (order: 0, 4096 bytes) UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) NET: Registered protocol family 1 PCI: CLS 0 bytes, default 32 squashfs: version 4.0 (2009/01/31) Phillip Lougher JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. msgmni has been set to 1008 io scheduler noop registered io scheduler deadline registered (default) mv_xor_shared mv_xor_shared.0: Marvell shared XOR driver mv_xor_shared mv_xor_shared.1: Marvell shared XOR driver mv_xor mv_xor.0: Marvell XOR: ( xor cpy ) mv_xor mv_xor.1: Marvell XOR: ( xor fill cpy ) mv_xor mv_xor.2: Marvell XOR: ( xor cpy ) mv_xor mv_xor.3: Marvell XOR: ( xor fill cpy ) Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled serial8250.0: ttyS0 at MMIO 0xf1012000 (irq = 33) is a 16550A console [ttyS0] enabled brd: module loaded loop: module loaded sata_mv sata_mv.0: version 1.28 sata_mv sata_mv.0: slots 32 ports 1 scsi0 : sata_mv ata1: SATA max UDMA/133 irq 21 NAND device: Manufacturer ID: 0x20, Chip ID: 0x76 (ST Micro NAND 64MiB 3,3V 8-bit) Scanning device for bad blocks Creating 4 MTD partitions on "orion_nand": 0x000000000000-0x000000100000 : "u-boot" 0x000000100000-0x000000300000 : "uImage" 0x000000300000-0x000000b00000 : "rootfs" 0x000000b00000-0x000004000000 : "rootfs_data" mv643xx_eth: MV-643xx 10/100/1000 ethernet driver version 1.4 mv643xx_eth smi: probed mv643xx_eth_port mv643xx_eth_port.0: eth0: port 0 with MAC address 00:90:0b:1a:36:87 mv643xx_eth_port mv643xx_eth_port.1: eth1: port 0 with MAC address 00:90:0b:1a:36:88 ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver orion-ehci orion-ehci.0: Marvell Orion EHCI orion-ehci orion-ehci.0: new USB bus registered, assigned bus number 1 ata1: SATA link up 1.5 Gbps (SStatus 113 SControl F300) orion-ehci orion-ehci.0: irq 19, io mem 0xf1050000 ata1.00: ATA-8: TOSHIBA MK8046GSX, LB313J, max UDMA/100 ata1.00: 156301488 sectors, multi 16: LBA48 NCQ (depth 31/32) orion-ehci orion-ehci.0: USB 2.0 started, EHCI 1.00 hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected Initializing USB Mass Storage driver... usbcore: registered new interface driver usb-storage USB Mass Storage support registered. ata1.00: configured for UDMA/100 scsi 0:0:0:0: Direct-Access ATA TOSHIBA MK8046GS LB31 PQ: 0 ANSI: 5 rtc-mv rtc-mv: rtc core: registered rtc-mv as rtc0 i2c /dev entries driver Orion Watchdog Timer: Initial timeout 21 sec sd 0:0:0:0: [sda] 156301488 512-byte logical blocks: (80.0 GB/74.5 GiB) usb 1-1: new high-speed USB device number 2 using orion-ehci cpuidle: using governor ladder sd 0:0:0:0: [sda] Write Protect is off sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00 mmc0: mvsdio driver initialized, using GPIO 28 for card detection TCP cubic registered NET: Registered protocol family 17 Distributed Switch Architecture driver version 0.1 sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA eth0[0]: detected a Marvell 88E6161 (A1) switch hub 1-1:1.0: USB hub found hub 1-1:1.0: 2 ports detected sda: sda1 < sda5 > sd 0:0:0:0: [sda] Attached SCSI disk dsa slave smi: probed 8021q: 802.1Q VLAN Support v1.8 Gating clock of unused units before: 0x00dfc3fd after: 0x00cf41d9 rtc-mv rtc-mv: setting system clock to 2000-01-01 00:00:00 UTC (946684800) VFS: Mounted root (squashfs filesystem) readonly on device 31:2. Freeing init memory: 132K JFFS2 notice: (1527) jffs2_build_xattr_subsystem: complete building xattr subsystem, 0 of xdatum (0 unchecked, 0 orphan) and 0 of xref (0 dead, 0 orphan) found. Loading modules backported from Linux version master-2013-06-27-0-gdcfa6d5 Backport generated by backports.git backports-20130617-4-ge3220f5 cfg80211: Calling CRDA to update world regulatory domain cfg80211: World regulatory domain updated: cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) cfg80211: (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) PPP generic driver version 2.4.2 ip_tables: (C) 2000-2006 Netfilter Core Team NET: Registered protocol family 24 nf_conntrack version 0.5.0 (8069 buckets, 32276 max) mv643xx_eth_port mv643xx_eth_port.0: eth0: link up, 1000 Mb/s, full duplex, flow control disabled device aux entered promiscuous mode device eth0 entered promiscuous mode device lan1 entered promiscuous mode device lan2 entered promiscuous mode device lan3 entered promiscuous mode device lan4 entered promiscuous mode lan2: link up, 100 Mb/s, full duplex, flow control disabled br-lan: port 3(lan2) entered forwarding state br-lan: port 3(lan2) entered forwarding state
br-lan: port 3(lan2) entered forwarding state
| 
/1 
简体中文
繁體中文
English
日本語
Deutsch
한국 사람
بالعربية
TÜRKÇE
português
คนไทย
IP卡
狗仔卡
置顶卡
沉默卡
喧嚣卡
顶贴卡
显身卡