竞斗云的几个问题L大来看看能搞定不？

stoc***

最新编译固件内核日志
[   19.890299] firmware ath10k!QCA4019!hw1.0!firmware-6.bin: firmware_loading_store: map pages failed
[   20.715593] ath10k_ahb a000000.wifi: qca4019 hw1.0 target 0x01000000 chip_id 0x003b00ff sub 0000:0000
[   20.715638] ath10k_ahb a000000.wifi: kconfig debug 0 debugfs 1 tracing 0 dfs 1 testmode 1
[   20.727508] ath10k_ahb a000000.wifi: firmware ver 10.4-3.6-00140 api 5 features no-p2p,mfp,peer-flow-ctrl,btcoex-param,allows-mesh-bcast,no-ps crc32 ba79b746
[   20.773812] ath10k_ahb a000000.wifi: board_file api 2 bmi_id 0:16 crc32 6ce1f887
[   22.173647] ath10k_ahb a000000.wifi: htt-ver 2.2 wmi-op 6 htt-op 4 cal pre-cal-file max-sta 512 raw 0 hwcrypto 1
[   22.204190] ath: EEPROM regdomain: 0x0
[   22.204265] ath: EEPROM indicates default country code should be used
[   22.204312] ath: doing EEPROM country->regdmn map search
[   22.204402] ath: country maps to regdmn code: 0x3a
[   22.204850] ath: Country alpha2 being used: US
[   22.204910] ath: Regpair used: 0x3a
[   22.948388] firmware ath10k!QCA4019!hw1.0!firmware-6.bin: firmware_loading_store: map pages failed
[   22.948727] ath10k_ahb a800000.wifi: qca4019 hw1.0 target 0x01000000 chip_id 0x003b00ff sub 0000:0000
[   22.956359] ath10k_ahb a800000.wifi: kconfig debug 0 debugfs 1 tracing 0 dfs 1 testmode 1
[   22.971162] ath10k_ahb a800000.wifi: firmware ver 10.4-3.6-00140 api 5 features no-p2p,mfp,peer-flow-ctrl,btcoex-param,allows-mesh-bcast,no-ps crc32 ba79b746
[   23.014726] ath10k_ahb a800000.wifi: board_file api 2 bmi_id 0:17 crc32 6ce1f887
[   24.413227] ath10k_ahb a800000.wifi: htt-ver 2.2 wmi-op 6 htt-op 4 cal pre-cal-file max-sta 512 raw 0 hwcrypto 1
[   24.429880] ath: EEPROM regdomain: 0x0
[   24.429900] ath: EEPROM indicates default country code should be used
[   24.429911] ath: doing EEPROM country->regdmn map search
[   24.429933] ath: country maps to regdmn code: 0x3a
[   24.429948] ath: Country alpha2 being used: US
[   24.429960] ath: Regpair used: 0x3a
[   24.442786] kmodloader: done loading kernel modules from /etc/modules.d/*
[   49.151723] xt_FULLCONENAT: RFC3489 Full Cone NAT module
[   49.151723] xt_FULLCONENAT: Copyright (C) 2018 Chion Tang <tech@chionlab.moe>
[   51.655246] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   51.660019] br-lan: port 1(eth0.1) entered blocking state
[   51.660057] br-lan: port 1(eth0.1) entered disabled state
[   51.665948] device eth0.1 entered promiscuous mode
[   51.670838] device eth0 entered promiscuous mode
[   51.681946] br-lan: port 1(eth0.1) entered blocking state
[   51.682000] br-lan: port 1(eth0.1) entered forwarding state
[   51.686710] IPv6: ADDRCONF(NETDEV_UP): br-lan: link is not ready
[   52.714575] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   52.715535] IPv6: ADDRCONF(NETDEV_CHANGE): br-lan: link becomes ready
[   55.556852] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   57.210582] IPv6: ADDRCONF(NETDEV_UP): wlan1: link is not ready
[   57.216424] br-lan: port 2(wlan0) entered blocking state
[   57.216470] br-lan: port 2(wlan0) entered disabled state
[   57.221732] device wlan0 entered promiscuous mode
[   57.227080] br-lan: port 3(wlan1) entered blocking state
[   57.230929] br-lan: port 3(wlan1) entered disabled state
[   57.236884] device wlan1 entered promiscuous mode
[   57.871405] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   57.871667] br-lan: port 2(wlan0) entered blocking state
[   57.876928] br-lan: port 2(wlan0) entered forwarding state
[   58.077054] IPv6: ADDRCONF(NETDEV_CHANGE): wlan1: link becomes ready
[   58.077661] br-lan: port 3(wlan1) entered blocking state
[   58.082538] br-lan: port 3(wlan1) entered forwarding state
[   81.629191] ess_edma c080000.edma: IPv6 not supported
[ 1154.615982] ess_edma c080000.edma: IPv6 not supported
[ 1156.584505] ess_edma c080000.edma: IPv6 not supported
[ 1158.420497] ess_edma c080000.edma: IPv6 not supported
[ 1159.840713] ess_edma c080000.edma: IPv6 not supported
[ 1194.957764] ess_edma c080000.edma: IPv6 not supported
[ 1197.820824] ess_edma c080000.edma: IPv6 not supported
[ 1201.095560] ess_edma c080000.edma: IPv6 not supported
[ 1203.247293] ess_edma c080000.edma: IPv6 not supported
[ 1207.414082] ess_edma c080000.edma: IPv6 not supported
[ 1209.452431] ess_edma c080000.edma: IPv6 not supported
[ 1211.466908] ess_edma c080000.edma: IPv6 not supported
[ 1213.832514] ess_edma c080000.edma: IPv6 not supported
[ 1218.689055] ess_edma c080000.edma: IPv6 not supported
[ 1220.696728] ess_edma c080000.edma: IPv6 not supported
[ 1222.758458] ess_edma c080000.edma: IPv6 not supported
[ 1223.497353] ess_edma c080000.edma: IPv6 not supported
[ 1225.297922] ess_edma c080000.edma: IPv6 not supported
[ 1226.841027] ess_edma c080000.edma: IPv6 not supported
[ 1228.368264] ess_edma c080000.edma: IPv6 not supported
[ 1230.882020] ess_edma c080000.edma: IPv6 not supported
[ 1289.469215] ess_edma c080000.edma: IPv6 not supported
[ 1358.708293] ess_edma c080000.edma: IPv6 not supported
[ 1413.755653] ess_edma c080000.edma: IPv6 not supported
[ 2243.219451] ess_edma c080000.edma: IPv6 not supported
[ 2244.419962] ess_edma c080000.edma: IPv6 not supported
[ 2245.645855] ess_edma c080000.edma: IPv6 not supported
[ 2248.508775] ess_edma c080000.edma: IPv6 not supported
[ 2249.294958] ess_edma c080000.edma: IPv6 not supported
[ 2330.776881] ess_edma c080000.edma: IPv6 not supported
[ 2333.175106] ess_edma c080000.edma: IPv6 not supported
[ 2337.989592] ess_edma c080000.edma: IPv6 not supported
[ 2340.489521] ess_edma c080000.edma: IPv6 not supported
[ 2342.801312] ess_edma c080000.edma: IPv6 not supported
[ 2343.026982] ess_edma c080000.edma: IPv6 not supported
这个IPV6错蛋疼只要访问IPV6就给你来一条，几小时后就刷满这货了，其他问题日志也看不到，但IPV6用着一点没问题，看着闹心， firmware ath10k!QCA4019失败也不知有啥问题不？另外路由PING自己1到4毫秒波动(CPU基本在0负载状态下），原厂固件似乎好些，其他就是USB3.0问题了，现在挂个USB2HUB凑合用着，换两个贴片电容的朋友说说到底行不行?

verg***

看我帖子 成功识别 还未测速

stoc***

感谢L大干掉了这个IPV6狂刷日志

target

ipq40xx: less ess_edma ipv6 log output