|
昨天在亲戚家淘到一个变成砖头的wr841n,是v8版本的,上电后所有指示灯闪烁一次后熄灭。
我把它拆开,按论坛里的帖子,自己焊上了TTL插针,然后用TTL线连上路由器,现在把输出信息贴出
=================================================================
________ __ __ ____ _ __ ___
|________|| ___ | | | | || \ | || | / /
| | | |___| | __ __ | | | || \| || |/ /
| | | _____| |__ __| | |___ | || |\ || \
|__| |__| |______||__||_| \____||__|\___\
Software Platform for MIPS
Creation date: Feb 1 2012, 15:11:37 (huangqingjia@tp-link.net)
Copyright(C) 2001-2012 by TP-LINK TECHNOLOGIES CO., LTD.
CPU: AR9341: AP123 Board
CPU freq: 500 MHZ
SDRAM size: 16 MB
ipaddr:192.168.1.1
serverip:192.168.1.100
file:vxWorks.img
Press Ctrl+C to stop auto-boot...
0
auto-booting...
Uncompressing...error
Can't load boot file!!
Stop auto-boot...
Attaching interface lo0... done
Rx clbufs 2048 each of size 1756
eth_rx_netpool_init: allocated, pDmaBuf=0x80be20d0, buffend = 80f540d4
ATHRS27: resetting s27
ATHRS27: s27 reset done
eth_rx_netpool_init: done already!
interrupt: enet1 port0 up
interrupt: LAN Port Interface type is 0x4c04
Attached IPv4 interface to eth unit 0
#
=================================================================
请问我现在要怎样才能刷入固件呢?百度 谷歌都搜过了,没找到有用的信息,特来坛里寻求帮助。。 |
|