小米路由2 黄灯常亮 TTL显示卡这就没下文了 请问大神还有救吗

luxi2211

Detect memory size = 256 MB
Post lines...ok
Memory check ok!
Decompressing...done
Found a AMD NAND flash:
Total size:  512MB
Block size:  128KB
Page Size:   2048B
OOB Size:    64B
Sector size: 512B
Spare size:  16B
ECC level:   4 (4-bit)
Device ID: 0x01 0xdc 0x90 0x95 0x56 0x01
board=8, clk=1400


CFE version v1.0.4
BSP: 7.14.116 (r549303) based on BBP 1.0.37 for BCM947XX (32bit,SP,)
Build Date: Thu Aug 20 17:29:27 CST 2015 (szy@szy-rommaker)
Copyright (C) 2000-2008 Broadcom Corporation.

Init Arena
Init Devs.
Boot up from NAND flash...
Boot partition size = 262144(0x40000)
DDR Clock: 800 MHz
Info: DDR frequency set from clkfreq=1400,*800*
XXXXX chipattach,538: Don't need override the robosw port5 setting
et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 7.14.116 (r549303)
CPU type 0x0: 1400MHz
Tot mem: 262144 KBytes

CFE mem:    0x00F00000 - 0x017911CC (8982988)
Data:       0x00F595B8 - 0x00F59C30 (1656)
BSS:        0x00F59C40 - 0x00F8F1CC (218508)
Heap:       0x00F8F1CC - 0x0178F1CC (8388608)
Stack:      0x0178F1CC - 0x017911CC (8192)
Text:       0x00F00000 - 0x00F4D564 (316772)
Boot:       0x01792000 - 0x017D2000
Reloc:      I:00000000 - D:00000000

Device eth0:  hwaddr F0-B4-29-18-7A-DA, ipaddr 192.168.1.1, mask 255.255.255.0
        gateway not set, nameserver not set
compressed crc = 0x54f167e5 Both system failed. Choosing os1
bootargs: boot -loader=raw_brcmnand -addr=0x8000  nflash0.os0:
Loader:raw_brcmnand Filesys:raw Dev:nflash0.os0 File: Optionsnull)
Loading: compressed crc = 0x54f167e5  3133440 bytes read
Entry at 0x00008000
Closing network.
Starting program at 0x00008000

到这后就无反应了

chanwah2009

看来要重刷固件了

路由摧手

硬件问题了，小米的无论R1D 2D基本是渣渣，可靠性不敢恭维