|
U-Boot 1.1.3 (May 6 2016 - 17:53:58)
Board: Ralink APSoC DRAM: 64 MB
relocate_code Pointer at: 83fac000
enable ephy clock...done. rf reg 29 = 5
SSC disabled.
spi_wait_nsec: 29
spi device id: ef 40 18 0 0 (40180000)
find flash: W25Q128FV
raspi_read: from:30000 len:2000
raspi_read: from:30000 len:2000
============================================
RALINK u-boot_mt7620 Version: 0.0.0.1
--------------------------------------------
ASIC 7620_MP (Port5<->None)
DRAM component: 512 Mbits DDR, width 16
DRAM bus: 16 bit
Total memory: 64 MBytes
Flash component: SPI Flash
Date:May 6 2016 Time:17:53:58
============================================
icache: sets:512, ways:4, linesz:32 ,total:65536
dcache: sets:256, ways:4, linesz:32 ,total:32768
##### The CPU freq = 580 MHZ ####
estimate memory size =64 Mbytes
Press press WPS button for more than 2 seconds to run web failsafe mode
WPS button is pressed for: 0 second(s)
Catution: WPS button wasn't pressed or not long enough!
Continuing normal boot...
raspi_read: from:40028 len:6
bootdelay is 5
Hit password to stop autoboot: 5
raspi_read: from:30000 len:10000
Erasing SPI Flash...
raspi_erase: offs:0x30000 len:0x10000
.
Writing to SPI Flash...
raspi_write: 0x83f39828 to:0x30000 len:0x10000
.
done
## Booting image at bc050000 ...
raspi_read: from:50000 len:40
Image Name: MIPS OpenWrt Linux-3.14.18
Image Type: MIPS Linux Kernel Image (lzma compressed)
Data Size: 1166542 Bytes = 1.1 MB
Load Address: 80000000
Entry Point: 80000000
raspi_read: from:50040 len:11ccce
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
No initrd
## Transferring control to Linux (at address 80000000) ...
## Giving linux memsize in MB, 64
Starting kernel ...
[ 0.000000] Linux version 3.14.18 (qgj@sky) (gcc version 4.8.3 (OpenWrt/Linaro GCC 4.8-2014.04 r3200) ) #5 Tue Nov 15 18:06:00 CST 2016
[ 0.000000] Board has DDR1
[ 0.000000] Analog PMU set to hw control
[ 0.000000] Digital PMU set to hw control
[ 0.000000] SoC Type: Ralink MT7620N ver:2 eco:6
[ 0.000000] bootconsole [early0] enabled
[ 0.000000] CPU0 revision is: 00019650 (MIPS 24KEc)
[ 0.000000] MIPS: machine is SR1B board |
|