|
U-Boot 1.1.4-gbc73b198 (Mar 29 2018 - 15:36:58)
ap152 - Dragonfly 1.0DRAM:
sri
ath_ddr_initial_config(278): (ddr2 init)
ath_sys_frequency: cpu 775 ddr 650 ahb 258
Tap values = (0xe, 0xe, 0xe, 0xe)
64 MB
Top of RAM usable for U-Boot at: 84000000
Reserving 202k for U-Boot at: 83fcc000
Reserving 192k for malloc() at: 83f9c000
Reserving 44 Bytes for Board Info at: 83f9bfd4
Reserving 36 Bytes for Global Data at: 83f9bfb0
Reserving 128k for boot params() at: 83f7bfb0
Stack Pointer at: 83f7bf98
Now running in RAM - U-Boot at: 83fcc000
Flash Manuf Id 0xc8, DeviceId0 0x40, DeviceId1 0x18
flash size 16MB, sector count = 256
Flash: 16 MB
*** Warning - bad CRC, using default environment
Power up PLL with outdiv = 0 then switch to 3
In: serial
Out: serial
Err: serial
Net: ath_gmac_enet_initialize...
No valid address in Flash. Using fixed address
ath_gmac_enet_initialize: reset mask:c02200
athr_mgmt_init ::done
Dragonfly ----> S17 PHY *
athrs17_reg_init: complete
SGMII in forced mode
athr_gmac_sgmii_setup SGMII done
: cfg1 0x80000000 cfg2 0x7114
eth0: 00:03:7f:09:0b:ad
eth0 up
eth0
Setting 0x181162c0 to 0x4b962100
Hit any key to stop autoboot: 0
## Booting image at 9f090000 ...
Image Name: MIPS OpenWrt Linux-3.3.8
Created: 2018-03-29 7:46:08 UTC
Image Type: MIPS Linux Multi-File Image (lzma compressed)
Data Size: 1046796 Bytes = 1022.3 kB
Load Address: 80060000
Entry Point: 80060000
Contents:
Image 0: 1046788 Bytes = 1022.3 kB
Verifying Checksum at 0x9f090040 ...OK
Uncompressing Multi-File Image ... OK
No initrd
## Transferring control to Linux (at address 80060000) ...
## Giving linux memsize in bytes, 67108864
Starting kernel ...
|
|