|
本帖最后由 ls.loveless 于 2020-6-29 16:33 编辑
zyguowei 发表于 2020-6-26 22:05
不要怂 , 大胆干..........单击图片放大
大佬,我设置了spi启动,但是刷不了cfe,也不知道怎么操作。
CFE version 6.37.14.126 (r561982) based on BBP 1.0.37 for BCM947XX (32bit,SP,)
Build Date: Wed May 20 00:16:13 CST 2020 (qin@ubuntu-wk)
Copyright (C) 2000-2008 Broadcom Corporation.
Init Arena
Init Devs.
Boot partition size = 262144(0x40000)
*** flash_nflash_init ***
Found a Samsung NAND flash:
Total size: 128MB
Block size: 128KB
Page Size: 2048B
OOB Size: 64B
Sector size: 512B
Spare size: 16B
ECC level: 8 (8-bit)
Device ID: 0xec 0xf1 0x00 0x95 0x40 0xec
DDR Clock: 666 MHz
Info: DDR frequency set from clkfreq=1000,*666*
et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 6.37.14.126 (r561982)
CPU type 0x0: 800MHz
Tot mem: 262144 KBytes
CFE mem: 0x00F00000 - 0x01796238 (9003576)
Data: 0x00F4E868 - 0x00F4ED64 (1276)
BSS: 0x00F4ED70 - 0x00F94238 (283848)
Heap: 0x00F94238 - 0x01794238 (8388608)
Stack: 0x01794238 - 0x01796238 (8192)
Text: 0x00F00000 - 0x00F44FA0 (282528)
Device eth0: hwaddr 18-31-00-00-00-00, ipaddr 192.168.1.1, mask 255.255.255.0
gateway not set, nameserver not set
Null Rescue Flag.
Hello!! Enter Rescue Mode: (by Force)
Reading ::
TFTP Server.
..tftp retry wait 0
Failed.: Timeout occured
Reading ::
TFTP Server.
..tftp retry wait 0
Failed.: Timeout occured
Reading ::
TFTP Server.
..tftp retry wait 0
Failed.: Interrupted
CFE> ^C
CFE> ^C
CFE> ^C
CFE> nflash0: Device not found
flash -noheader 192.168.1.100:cfe_r6300v2_qin.bin nflash0
nflash0: Device not found
*** command status = -6
CFE> flash -noheader 192.168.1.100:cfe_r6300v2_qin.bin eth0
Device 'eth0' is not a flash or eeprom device.
*** command status = -8
CFE> flash -noheader 192.168.1.100:cfe_r6300v2_qin.bin nflash0
nflash0: Device not found
*** command status = -6
|
|