linksys wrt-1900ac 刷openwrt 惨啊

xphls

大家都说3方固件好，就拿去刷，结果刷一半就费了，  妈的这家伙太贵了，
这种情况有的救吗？

xphls

官网说只要捅，复位键10秒 ，就可以恢复原厂..............
看来菜鸟真的不适合刷机啊
看看能不能退返给洋人！唉.....

温馨提醒：菜鸟别刷太贵的路由器 呵呵

zheda3030

I've found a way to manually switch the wrt1900ac from a trashed flash, to the secondary flash... It's done as follows:

Reset the router by holding the reset button in until the PWR light starts to flash {mine takes about 15 sec's}
Once the power light stops flashing, you can power off the router with the power switch.

Turn the power back on and the PWR light will light. As soon as any other light turns on, power off the router with the power switch.

Turn the power back on and the PWR light will light. As soon as any other light turns on, power off the router with the power switch.
Turn the power back on and the PWR light will light. As soon as any other light turns on, power off the router with the power switch.

Turn the power back on and the PWR light will light. This time just let the router power all the way up. It should now be on the alternate firmware.

Yes, you will power off three times. Hope this works for you-all...

~Tim~

Chadster Note:

Keep in mind that if the previous firmware was OpenWRT it will load that version of OpenWRT and the last settings used in OpenWRT.

Also it worked for me to repeatedly turn the router on and off 3 or 4 times quickly caused it to revert to the previous firmware.

这个还帮不了你的话就只能当垃圾卖了

wxhjz

土豪。你买这做什么用途？能否介绍一下？

linux_pro

回收........................

kmper

1元包邮回收