求教DW33D拆掉NAND刷固件不启动

ht619***

Boot and Recovery Environment for Embedded Devices
Copyright (C) 2018 HackPascal <hackpascal@gmail.com>
Build date 2018-03-23 [git-994feec]
Version 1.1 (r1211)

DRAM: 256MB
Platform: Qualcomm Atheros QCA9558 rev 0
Board: DomyWiFi DW33D
Clocks: CPU: 720MHz, DDR: 600MHz, AHB: 200MHz, Ref: 40MHz
ath79-nand: NAND Parameter page read failed
Unknown NAND ID: 00:00:00:00:00
No NAND Flash found
Flash: Winbond W25Q128 (16MB) on ath79-spi
ag71xx-eth: MAC address is invalid, using default settings.
ag71xx-eth: Using MAC address 00:13:74:00:00:01
Waiting for auto-negotiation complete ... OK
eth0: Qualcomm Atheros QCA8337 rev 2

Network started on eth0, inet addr 192.168.1.1, netmask 255.255.255.0

Press any key to interrupt autoboot ... 0   

Trying to boot firmware from 0x9fe80000 ...
U-Boot firmware image header detected.
    Image Name:   MIPS OpenWrt Linux-4.4.111
    Data Size:    1428023 Bytes
    Load Address: 80060000
    Entry Point:  80060000
Uncompressing data (LZMA) ... done.
Flushing cache ... done.

Starting kernel at 0x80060000...

[    0.000000] Linux version 4.4.111 (root@debian8) (gcc version 5.5.0 (OpenWrt GCC 5.5.0 r0+29-1a47adf) ) #0 Sun Mar 11 13:39:17 2018
[    0.000000] bootconsole [early0] enabled
[    0.000000] CPU0 revision is: 00019750 (MIPS 74Kc)
[    0.000000] SoC: Qualcomm Atheros QCA9558 ver 1 rev 0
[    0.000000] Determined physical RAM map:
[    0.000000]  memory: 10000000 @ 00000000 (usable)
[    0.000000] User-defined physical RAM map:
[    0.000000]  memory: 10000000 @ 00000000 (usable)
[    0.000000] No valid device tree found, continuing without
[    0.000000] Zone ranges:
[    0.000000]   Normal   [mem 0x0000000000000000-0x000000000fffffff]
[    0.000000] Movable zone start for each node
[    0.000000] Early memory node ranges
[    0.000000]   node   0: [mem 0x0000000000000000-0x000000000fffffff]
[    0.000000] Initmem setup node 0 [mem 0x0000000000000000-0x000000000fffffff]
[    0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
[    0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
[    0.000000] Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 65024
[    0.000000] Kernel command line:  board=DW33D mtdparts=spi0.0:256k(u-boot)ro,64k(u-boot-env)ro,14528k(rootfs),1472k(kernel),64k(art)ro,16000k@0x50000(firmware);ar934x-nfc:96m(rootfs_data),32m(backup)ro mem=256M console=ttyS0,115200
[    0.000000] PID hash table entries: 1024 (order: 0, 4096 bytes)
[    0.000000] Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
[    0.000000] Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
[    0.000000] Writing ErrCtl register=00000000
[    0.000000] Readback ErrCtl register=00000000
[    0.000000] Memory: 254708K/262144K available (3341K kernel code, 159K rwdata, 812K rodata, 224K init, 198K bss, 7436K reserved, 0K cma-reserved)
[    0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[    0.000000] NR_IRQS:51
[    0.000000] Clocks: CPU:720.000MHz, DDR:600.000MHz, AHB:200.000MHz, Ref:40.000MHz
[    0.000000] clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 5309056796 ns
[    0.000007] sched_clock: 32 bits at 360MHz, resolution 2ns, wraps every 5965232126ns
[    0.008670] Calibrating delay loop... 358.80 BogoMIPS (lpj=1794048)
[    0.071708] pid_max: default: 32768 minimum: 301
[    0.076954] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes)
[    0.084333] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes)
[    0.094424] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns
[    0.105409] futex hash table entries: 256 (order: -1, 3072 bytes)
[    0.112745] NET: Registered protocol family 16
[    0.118462] CPU 0 Unable to handle kernel paging request at virtual address 00000004, epc == 801eb450, ra == 8015f590
[    0.130312] Oops[#1]:
[    0.132838] CPU: 0 PID: 1 Comm: swapper Not tainted 4.4.111 #0
[    0.139330] task: 8fc34000 ti: 8fc22000 task.ti: 8fc22000
[    0.145336] $ 0   : 00000000 00000000 8fc0d380 00000000
[    0.151144] $ 4   : 8fc52d30 8fc0d34c 00000000 8fc4e180
[    0.156952] $ 8   : fffffffc 8fc4e9e0 00000000 00000001
[    0.162760] $12   : 804784a8 ffffff80 00000000 6f746f63
[    0.168568] $16   : 8fc52d20 00000000 80480000 8fc0d320
[    0.174376] $20   : 80480000 00000100 80470000 804d0000
[    0.180184] $24   : 00000003 00000000                  
[    0.185992] $28   : 8fc22000 8fc23c80 804d0000 8015f590
[    0.191800] Hi    : 0000001e
[    0.194994] Lo    : 00000002
[    0.198215] epc   : 801eb450 rb_insert_color+0x2c/0x158
[    0.204029] ra    : 8015f590 kernfs_link_sibling+0xc4/0x100
[    0.210227] Status: 1100cc03 KERNEL EXL IE
[    0.214875] Cause : 00800008 (ExcCode 02)
[    0.219326] BadVA : 00000004
[    0.222522] PrId  : 00019750 (MIPS 74Kc)
[    0.226876] Modules linked in:
[    0.230269] Process swapper (pid: 1, threadinfo=8fc22000, task=8fc34000, tls=00000000)
[    0.239082] Stack : 00000001 000041ed 8fc04b00 8015e778 ffffffff fffffffe 8fc52d20 8015fb04
          395f7365 8fc0d320 8047a260 8fc0d320 804893a0 80480000 8fc0d320 8015f8cc
          80480000 80000000 00000001 8fc52d20 8047a260 8fc0d320 804893a0 8015fbdc
          804d0000 801e7a34 80470000 8fc0d4b0 8047a260 8fc0d320 804893a8 80162254
          8fc03410 8fc52cd0 8044697c 76f02b7f 00000000 8fc730dd 8fc73800 8047a260
          ...
[    0.278577] Call Trace:
[    0.281294] [<801eb450>] rb_insert_color+0x2c/0x158
[    0.286723] [<8015f590>] kernfs_link_sibling+0xc4/0x100
[    0.292540] [<8015fb04>] kernfs_add_one+0xec/0x174
[    0.297872] [<8015fbdc>] kernfs_create_dir_ns+0x50/0x8c
[    0.303694] [<80162254>] sysfs_create_dir_ns+0x54/0xa0
[    0.309410] [<801e83b0>] kobject_add_internal+0xcc/0x2c8
[    0.315323] [<801e8634>] kobject_add+0x88/0xac
[    0.320283] [<80243bf8>] device_add+0x114/0x55c
[    0.325334] [<802480f4>] platform_device_add+0x194/0x230
[    0.331264] [<8049ba8c>] ath79_gpio_init+0xc4/0x110
[    0.336690] [<80499af8>] ath79_setup+0x3c/0x64
[    0.341647] [<8006ddf0>] do_one_initcall+0x1e8/0x214
[    0.347171] [<80498d14>] kernel_init_freeable+0x164/0x224
[    0.353194] [<80069394>] kernel_init+0x10/0x114
[    0.358231] [<80064878>] ret_from_kernel_thread+0x14/0x1c
[    0.364236]
[    0.365881]
Code: 30660001  14c0004a  00000000 <8c660004> 10460017  00000000  10c00005  00000000  8cc70000
[    0.376949] ---[ end trace 0be81de14c4ed683 ]---
[    0.382094] Kernel panic - not syncing: Attempted to kill init! exitcode=0x0000000b
[    0.382094]
[    0.392267] ---[ end Kernel panic - not syncing: Attempted to kill init! exitcode=0x0000000b
[    0.392267]
[   82.849082] random: nonblocking pool is initialized

ht619***

固件在spi里。。。为什么 拆掉nand会不启动呢。。。breed却一切正常

koc***

固件内有NAND的定义,去掉试试

ht619***

kochiya 发表于 2018-4-15 16:50
固件内有NAND的定义,去掉试试

多谢指点，我去补充点这方面知识

jsp***

ht61929765 发表于 2018-4-15 17:40
多谢指点，我去补充点这方面知识

我补张图就可以看到了g:\Untitled.jpg