wr841n v11升级 breed 启动不了

wgy***

wr841n v11升级 breed 启动不了. U-Boot-2014-09-04可以正常启动.

hackpascal麻烦帮忙看下，以下是TTL


Boot and Recovery Environment for Embedded Devices
Copyright (C) 2015 HackPascal <hackpascal@gmail.com>
Build date 2015-11-03 [git-0fd8ec8]
Version 1.0 (r791)

DRAM: 64MB
Platform: Qualcomm Atheros QCA953X rev 1
Board: Generic board
Clocks: CPU: 550MHz, DDR: 400MHz, AHB: 200MHz, Ref: 25MHz
Flash: Winbond W25Q128 (16MB) on ath79-spi
ag71xx-eth: Using MAC address 20:f3:e5:45:a6:48
eth0: Atheros AR8228/AR8229 rev 1

Network started on eth0, inet addr 192.168.1.1, netmask 255.255.255.0

Press any key to interrupt autoboot ... 0

Trying to boot firmware from 0x9f020000 ...
TP-LINK firmware image header detected.
    Image Name:   08410011
    Data Size:    1135696 Bytes
    Load Address: 80060000
    Entry Point:  80060000
Uncompressing data (LZMA) ... done.
Flushing cache ... done.

Starting kernel at 0x80060000...

[    0.000000] Linux version 3.18.23 (wgy@wgy-virtual-machine) (gcc version 4.8.3 (OpenWrt/Linaro GCC 4.8-2014.04 r47390) ) #1 Thu Nov 5 04:26:06 CST 2015
[    0.000000] bootconsole [early0] enabled
[    0.000000] CPU0 revision is: 00019374 (MIPS 24Kc)
[    0.000000] SoC: Qualcomm Atheros QCA9533 ver 1 rev 1
[    0.000000] Determined physical RAM map:
[    0.000000]  memory: 04000000 @ 00000000 (usable)
[    0.000000] Initrd not found or empty - disabling initrd
[    0.000000] Zone ranges:
[    0.000000]   Normal   [mem 0x00000000-0x03ffffff]
[    0.000000] Movable zone start for each node
[    0.000000] Early memory node ranges
[    0.000000]   node   0: [mem 0x00000000-0x03ffffff]
[    0.000000] Initmem setup node 0 [mem 0x00000000-0x03ffffff]
[    0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
[    0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
[    0.000000] Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 16256
[    0.000000] Kernel command line:  board=TL-WR841N-v11  console=ttyS0,115200 rootfstype=squashfs,jffs2 noinitrd
[    0.000000] PID hash table entries: 256 (order: -2, 1024 bytes)
[    0.000000] Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
[    0.000000] Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
[    0.000000] Writing ErrCtl register=0005f33b
[    0.000000] Readback ErrCtl register=0005f33b
[    0.000000] Memory: 60944K/65536K available (2476K kernel code, 127K rwdata, 528K rodata, 252K init, 188K bss, 4592K reserved)
[    0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[    0.000000] NR_IRQS:51
[    0.000000] Clocks: CPU:550.000MHz, DDR:400.000MHz, AHB:200.000MHz, Ref:25.000MHz
[    0.000000] Calibrating delay loop... 366.18 BogoMIPS (lpj=1830912)
[    0.060000] pid_max: default: 32768 minimum: 301
[    0.060000] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes)
[    0.070000] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes)
[    0.080000] NET: Registered protocol family 16
[    0.080000] MIPS: machine is TP-LINK TL-WR841N/ND v11
[    0.530000] Switched to clocksource MIPS
[    0.540000] NET: Registered protocol family 2
[    0.540000] TCP established hash table entries: 1024 (order: 0, 4096 bytes)
[    0.540000] TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
[    0.550000] TCP: Hash tables configured (established 1024 bind 1024)
[    0.560000] TCP: reno registered
[    0.560000] UDP hash table entries: 256 (order: 0, 4096 bytes)
[    0.570000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[    0.570000] NET: Registered protocol family 1
[    0.580000] futex hash table entries: 256 (order: -1, 3072 bytes)
[    0.610000] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[    0.610000] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[    0.620000] msgmni has been set to 119
[    0.630000] io scheduler noop registered
[    0.630000] io scheduler deadline registered (default)
[    0.640000] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
[    0.640000] console [ttyS0] disabled

到这里就卡住了