|
U-Boot 1.1.4 (Jun 18 2009 - 15:08:27)
AP81 (ar7100) U-boot
DRAM:
sri
32 MB
id read 0x100000ff
flash size 8MB, sector count = 128
Flash: 8 MB
Using default environment
In: serial
Out: serial
Err: serial
Net: ag7100_enet_initialize...
No valid address in Flash. Using fixed address
eth0: 00:03:7f:09:0b:ad
eth0 up
eth0
Autobooting in 1 seconds## Booting image at bf020000 ...
Uncompressing Kernel Image ... OK
Starting kernel ...
Linux version 2.6.32.27 (openwrtcn@openwrt) (gcc version 4.3.3 (GCC) ) #16 Mon Nov 14 13:31:32 CST 2011
bootconsole [early0] enabled
CPU revision is: 00019374 (MIPS 24Kc)
Atheros AR9132 rev 1, CPU:400.000 MHz, AHB:100.000 MHz, DDR:400.000 MHz
Determined physical RAM map:
memory: 02000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Zone PFN ranges:
Normal 0x00000000 -> 0x00002000
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
0: 0x00000000 -> 0x00002000
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128
Kernel command line: rootfstype=squashfs,yaffs,jffs2 noinitrd console=ttyS0,115200 board=TL-WR941ND
PID hash table entries: 128 (order: -3, 512 bytes)
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
Writing ErrCtl register=00000000
Readback ErrCtl register=00000000
Memory: 29336k/32768k available (2089k kernel code, 3432k reserved, 408k data, 148k init, 0k highmem)
SLUB: Genslabs=7, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
Hierarchical RCU implementation.
NR_IRQS:56
Calibrating delay loop... 266.24 BogoMIPS (lpj=1331200)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
MIPS: machine is TP-LINK TL-WR941ND
bio: create slab <bio-0> at 0
Switching to clocksource MIPS
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
NET: Registered protocol family 1
squashfs: version 4.0 (2009/01/31) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2. (NAND) (SUMMARY) ? 2001-2006 Red Hat, Inc.
yaffs Nov 14 2011 12:38:19 Installing.
msgmni has been set to 57
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A
console [ttyS0] enabled, bootconsole disabled
console [ttyS0] enabled, bootconsole disabled
Atheros AR71xx SPI Controller driver version 0.2.4
m25p80 spi0.0: 320s33b (8192 Kbytes)
Searching for RedBoot partition table in spi0.0 at offset 0x7e0000
Searching for RedBoot partition table in spi0.0 at offset 0x7f0000
No RedBoot partition table detected in spi0.0
spi0.0: no WRT160NL signature found
Creating 5 MTD partitions on "spi0.0":
0x000000000000-0x000000020000 : "u-boot"
0x000000020000-0x000000160000 : "kernel"
0x000000160000-0x0000007f0000 : "rootfs"
mtd: partition "rootfs" set to be root filesystem
mtd: partition "rootfs_data" created automatically, ofs=790000, len=60000
0x000000790000-0x0000007f0000 : "rootfs_data"
0x0000007f0000-0x000000800000 : "art"
0x000000020000-0x0000007f0000 : "firmware"
ag71xx_mdio: probed
eth0: Atheros AG71xx at 0xb9000000, irq 4
Atheros AR71xx hardware watchdog driver version 0.1.0
TCP westwood registered
NET: Registered protocol family 17
Distributed Switch Architecture driver version 0.1
ar7240_dsa: unsupported chip, ctrl=ffffffff
eth0[0]: detected a Marvell 88E6060 switch
dsa slave smi: probed
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
SQUASHFS error: squashfs_read_data failed to read block 0x61e634
SQUASHFS error: Unable to read metadata cache entry [61e634]
SQUASHFS error: Unable to read inode 0x411e0f6e
------------[ cut here ]------------
WARNING: at fs/inode.c:712 0x800f5650()
Modules linked in:
Call Trace:[<80069348>] 0x80069348
[<80069348>] 0x80069348
[<800874d0>] 0x800874d0
[<800f5650>] 0x800f5650
[<800f5650>] 0x800f5650
[<8012f164>] 0x8012f164
[<800f78ec>] 0x800f78ec
[<8012e778>] 0x8012e778
[<8017e838>] 0x8017e838
[<800e4570>] 0x800e4570
[<80125ce4>] 0x80125ce4
[<8010e4ac>] 0x8010e4ac
[<800e4b2c>] 0x800e4b2c
[<800e37ec>] 0x800e37ec
[<800fa694>] 0x800fa694
[<8012e158>] 0x8012e158
[<8012e228>] 0x8012e228
[<800e3890>] 0x800e3890
[<800e398c>] 0x800e398c
[<800f7094>] 0x800f7094
[<800fb9ec>] 0x800fb9ec
[<800fbb04>] 0x800fbb04
[<800ed854>] 0x800ed854
[<802d1cc4>] 0x802d1cc4
[<801ae964>] 0x801ae964
[<802d20c4>] 0x802d20c4
[<800b5390>] 0x800b5390
[<802d1388>] 0x802d1388
[<8006d960>] 0x8006d960
[<802d126c>] 0x802d126c
[<8006d950>] 0x8006d950
---[ end trace efb6c149a6760d79 ]---
VFS: Cannot open root device "<NULL>" or unknown-block(31,2)
Please append a correct "root=" boot option; here are the available partitions:
1f00 128 mtdblock0 (driver?)
1f01 1280 mtdblock1 (driver?)
1f02 6720 mtdblock2 (driver?)
1f03 384 mtdblock3 (driver?)
1f04 64 mtdblock4 (driver?)
1f05 8000 mtdblock5 (driver?)
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,2)
请各位帮忙看一下是什么问题~!谢谢 |
|